SS-G105
Sino Star
| Quantity: | |
|---|---|
Product name : Multi-function Cleaning Spray Gun
Model number: SS-G105
Technical Specification:
| Model | SS-G105 |
| Weight | 1.45KG |
| Air Flow Rate | 1601/min at 0.5Mpa |
| Air Pressure | 0.4 to 0.8 Mpa |
| Application | Cleaning the surface of wheel and engine |
| Solution | PH=7 |
| Operate TEMP | 10-50℃ |
Function:
Cleaning the surface of wheel and engine.
Advantage:
Reduction by 40% in weight working at low -pressure
Maintenance Method:
You have to clean and dry the tool after using it, otherwise, the liquid wuill damage inside the tool due to the dust and bacteria, so that cut down the working lift.
Clean method: make the bell into the water and hold down the trigger, then dry it and put it on the place where ventilated. Dry and have not sun shine. As below:
Clean the equipment, you only put the bell into the water and hold down the trigger about 1-3 seconds.
Note:
Please make the air compressor keep the pressure during 0.4-0.8Mpa. It is better for your cleaning effect.
Please confim that the Pipe is pushed into the bottom cfjoint before using, if not, it will hurt you.
Pease don't make the brush toward to your body, face and eyes when you use it.
It is best to use mask to protect your eyes and face when you use it.
Warning:
Please stop to use it and back to factory for repair if the tools was demaged or have unusual during using time.
You have to repair, reform and check up the tool if have any question in our authorised maintenance center. We will not be in charge of equipment because of destroy from original parts, special liquid, repair and change the fittings by yourself, even if during the warranty period.
Product name : Multi-function Cleaning Spray Gun
Model number: SS-G105
Technical Specification:
| Model | SS-G105 |
| Weight | 1.45KG |
| Air Flow Rate | 1601/min at 0.5Mpa |
| Air Pressure | 0.4 to 0.8 Mpa |
| Application | Cleaning the surface of wheel and engine |
| Solution | PH=7 |
| Operate TEMP | 10-50℃ |
Function:
Cleaning the surface of wheel and engine.
Advantage:
Reduction by 40% in weight working at low -pressure
Maintenance Method:
You have to clean and dry the tool after using it, otherwise, the liquid wuill damage inside the tool due to the dust and bacteria, so that cut down the working lift.
Clean method: make the bell into the water and hold down the trigger, then dry it and put it on the place where ventilated. Dry and have not sun shine. As below:
Clean the equipment, you only put the bell into the water and hold down the trigger about 1-3 seconds.
Note:
Please make the air compressor keep the pressure during 0.4-0.8Mpa. It is better for your cleaning effect.
Please confim that the Pipe is pushed into the bottom cfjoint before using, if not, it will hurt you.
Pease don't make the brush toward to your body, face and eyes when you use it.
It is best to use mask to protect your eyes and face when you use it.
Warning:
Please stop to use it and back to factory for repair if the tools was demaged or have unusual during using time.
You have to repair, reform and check up the tool if have any question in our authorised maintenance center. We will not be in charge of equipment because of destroy from original parts, special liquid, repair and change the fittings by yourself, even if during the warranty period.
