SS-G106
Sino Star
| Quantity: | |
|---|---|
Product name : Special Cleaning Spray Gun For Engine
Model number: SS-G106
Technical Specification:
| Model | SS-G106 |
| Weight | 1.80KG |
| Liquid Flew | 10L/h |
| Flow | 1-10μm |
| Air Pressure | 0.4 to 0.8 Mpa |
| Application | Clean stubborn stains in corner of the engine and car body |
| Solution | PH=7 |
| Operate TEMP | 10-50 |
| Spray particle | 5UM-10UM |
Function:
Special remove the dirt and dust on the surface and in the gap.
Advantage:
Reduction by 40% in weight working at low -pressure
Set Up And Tear Down Description:
1. Set up the pipe
You only make the pipe push into the relevant joint then it will be got stuck tightly. Please pull it lightly that if the pipe is set up well.(PIC1)
2. Tear down the pipe
First, press down the fastener, then pull out the pipe with another hand.(PIC2)
Note:
You must confirm the pipe if is set up well before using, if not the liquid and air will be reveal to appear danger.
Cleaning Description:
1. Open the liquid contro| value, hold down the trigger, make the dirt emulsify and blow away.
2. Close the liquid control valve, hold down the trigger, make the left water and dirt blow away by airflow.
3. Finally, put the brush into the water for cleaning if it is very dirty.
Warning:
Please confirm that if the joint is set up well before using. if not , it will hurt you , it is very dangerous.
Please stop to use it and back to factory for repair if the tools was damaged or have unusual during using time.
Product name : Special Cleaning Spray Gun For Engine
Model number: SS-G106
Technical Specification:
| Model | SS-G106 |
| Weight | 1.80KG |
| Liquid Flew | 10L/h |
| Flow | 1-10μm |
| Air Pressure | 0.4 to 0.8 Mpa |
| Application | Clean stubborn stains in corner of the engine and car body |
| Solution | PH=7 |
| Operate TEMP | 10-50 |
| Spray particle | 5UM-10UM |
Function:
Special remove the dirt and dust on the surface and in the gap.
Advantage:
Reduction by 40% in weight working at low -pressure
Set Up And Tear Down Description:
1. Set up the pipe
You only make the pipe push into the relevant joint then it will be got stuck tightly. Please pull it lightly that if the pipe is set up well.(PIC1)
2. Tear down the pipe
First, press down the fastener, then pull out the pipe with another hand.(PIC2)
Note:
You must confirm the pipe if is set up well before using, if not the liquid and air will be reveal to appear danger.
Cleaning Description:
1. Open the liquid contro| value, hold down the trigger, make the dirt emulsify and blow away.
2. Close the liquid control valve, hold down the trigger, make the left water and dirt blow away by airflow.
3. Finally, put the brush into the water for cleaning if it is very dirty.
Warning:
Please confirm that if the joint is set up well before using. if not , it will hurt you , it is very dangerous.
Please stop to use it and back to factory for repair if the tools was damaged or have unusual during using time.
